How To Set Up A Fish Tank? Or Fish Tank Installation

We express that how to set up a fish tank? Before considering the size of the fish tank and where to put it in the room, you should locate the nearest dealer. Once you have found the fish tank store you have to take a general tour of the interior before buying any equipment or deciding something. Is this store going to be able to supply you with the accessories you need? Is the staff attentive? Most important of all, are the tanks always clean and tidy? Do the fish look healthy? If you take a good look in a fish tank and there are several dead fish in it or if they have several fish tanks with strange fish, go out and take your order somewhere else. Are there many customers going into the store? If so, this is usually a sign that the store is trustworthy. In most cases it is better to go to a fish tank dealer rather than a pet store. There are many pet stores that have good stocks of tropical fish and keep them in excellent condition, but they usually handle a wide variety of animals and may not be able to give you the specialized help you need. Once you have located a nearby dealer and have seen all the enchanting exotic fish you can consider, it is time to start.

If you buy a glass fish tank, be sure to put an expanded polyethylene blanket about 1.25 cm thick underneath the base. The polyethylene does not collapse due to the weight of the tank and, if there is a gap between the tank and the support, it will fill it, preventing the bottom glass from breaking. The initial setup is almost done, but now there are some loose ends to attend to. First, a glass cover is required; It is covered in glass or plastic and is placed on top of the fish tank and stops splashes that can come in contact with electricity and also prevents fish from jumping out. You can buy a plastic or glass cover from your dealer or get a cut-to-size piece of glass from a glass store but, In this case, ask them to cut the corners to make room for the wiring and that the devices need to work. Also, polish the rounded edges to avoid damaging your hands when cleaning the tank.

The next step is to connect the electric light. The heater / thermostat and air pump need electricity at all times, and the light must have a switch that allows you to turn it off at night. It is best to buy a switched connection block from your dealer, this will fit all the cables in your tank and allow you to use a single connection, they generally have a light switch and a spare one and it is a good investment. Having wired everything correctly and checked to make sure there is no water splash in the electrical system, plug it in and turn it on. When the water and electricity are together it is vital to ensure that they do not come into contact with each other, if this happens while you have your hands in the tank, you could be in for an unpleasant surprise. It is good to buy a circuit breaker,

There are test kits to measure the acid / alkaline balance of your fish tank and most use the principle of color dye. The scale used is PH, which ranges from PO (very acidic) to PH 14 (very alkaline), with PH 7 as neutral. This means that PH 6 is ten times more acidic than PH 7 and PH 5 one hundred times more acidic than PH 7.

The PH values ​​of natural freshwater sources range from about PH6 for acidic and soft water like that of the Amazon River to about 8.5 PH like the hard and alkaline water of Lake Tanganyika in Africa. Some of the less tolerant fish in these environments only develop if the PH value of your fish tank reflects conditions in their natural habitat. The best way to make the water in your fish tank more acidic or alkaline is by using a PH regulator, a very easy kit to get from fish tank stores. There are other ways such as filtering through a peat to increase acidity, but these methods are a little unpredictable and can stress fish.



Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *


Back to top button